How to Repair Your Ice Maker of Your Fridge

0
113

You longing for an ice cold drink. You go to the ice maker and locate the worst case scenario: no ice. Now you have a lukewarm drinks and the question: what is wrong with my ice maker? To help you with this dilemma, here are some tips for troubleshooting broken ice maker.

How an Ice Maker Works

First, you need to understand how a piece of ice maker. First, there is ¼ inch water supply line that goes from the refrigerator to the water filter or water pipes. This is how the water supplied to the ice maker. This supply line leads to the water valve to fill the fridge, where it is controlled by a thermostat ice maker. Fill valve sends water through the filling tube into the assembly line that includes molds for ice, where water freezes and becomes ice.

Once the water is frozen, the thermostat turns off the water supply to the solenoid. A heater then turned on so that the ice a little warms enough to be released. An ice maker motors to rotate the arm and then turn on the ice ejection. Ejection arm works to push the ice cubes from the mold and into the ice collection bin. Then, the cycle repeats itself. After the ice collection bin is full, ice lead to wire bail, which shuts off the ice maker to lower the level of the ice.

Ice Maker Doesn’t Make Ice

Ice maker is not making ice has the potential for several causes. Here is how you can solve the problem for this problem:

First, check the wire bail and make sure it’s in the down position. If locked in the up position, the ice will not be created.

If this is not the problem, look at the water supply line. This may be a problem if you can see the swing arm ejection and you hear the buzz for about 10 seconds. This means asking for water, but did not get any. Check to make sure not to bend the supply line behind the refrigerator. Turn off the water by pulling the valve back of the refrigerator or under the sink, unscrewing the copper lines from the back of the refrigerator, put it in a bucket, turned on the water valve and see if water comes out.

Perhaps you had a bad press valve, which is what connects the water supply tubes to the water pipe. If this happens, you may need to replace it, as well as the valve inlet. It’s possible to buy a kit to do this yourself, or you can contact us to the fridge repair in pune, Kolkata, Delhi, Mumbai, Hyderabad and etc to hire best technicians and experts.

Finally, check the solenoid. It attaches to the water line behind the fridge and a trip to the ice maker. Ice maker you may not make ice as the solenoid is either broken or is not getting power. Unplug the refrigerator. Then, try to remove sediment screen is in the solenoid and flush with water. Check all seals to ensure that they have not been compromised. You may need to replace the solenoid immediately if this happens.

Of course, there are other problems you can run into with your ice maker. For this dilemma, be sure to watch out for our next blog, where we continue to provide a way to solve the problem of misery your ice maker. Meanwhile, when you’re looking for a fridge repair in Kolkata, Pune, Delhi, Mumbai, Hyderabad and etc, contact All Electric Care!